CC_RESET_CON

Section: Call Control Interface (CCI) (7)
Updated: 2008-10-31
Index Return to Main Contents

NAME

CC_RESET_CON - circuit reset confirmation

SYNOPSIS

The format of this message is one M_PROTO message block. The structure of the M_PROTO block is as follows:

DESCRIPTION

This primitive confirms to the requesting CCS user that the specified call control address(es) (signalling interface and circuit identifiers) have been successfully confirmed reset to the peer CCS user.

Parameters

This primitive contains the following parameters:

cc_primitive: indicates the primitive type. Always CC_RESET_CON.
cc_flags: Specifies options flags for the operation. (See ``Flags'', below.)
cc_addr_length: Indicates the length of the call control address(es) (signalling interface and circuit identifiers) upon which the CCS provider has confirmed a reset.
cc_addr_offset: Indicates the offset of the call control address(es) (signalling interface and circuit identifiers) from the beginning of the M_PROTO message block.

Flags

The options flags are protocol and provider-specific. For additional information, see the specific Addendum.

State

This primitive is valid in state CCS_WCON_RESREQ for the specified addresses. The new state is CCS_IDLE for the specified addresses.

Modes

This primitive will only be issued by the CCS provider for call control addresses in the NNI mode.

Originator

This primitive is issued by the CC Provider.

NOTES

Considerations for Q.764 and ANSI T1.113 conformance:

CCS providers conforming to Q.764 or ANS T1.113 adhere to the following additional rules: (See also cci_isup(7) for address format and isup(4))

Considerations for Q.931/932 conformance:

CCS providers conforming to Q.931/932 adhere to the following additional rules: (See also cci_isdn(7) for address format and isdn(4))

Considerations for H.225.0 conformance:

CCS providers conforming to H.225.0 adhere to the following additional rules: (See also cci_h225(7) for address format and h225(4))

Considerations for BSSAP conformance:

CCS providers conforming to BSSAP adhere to the following additional rules: (See also cci_bssap(7) for address format and bssap(4))

FILES

<ss7/cci.h>.

VERSIONS

This manpage was written for strss7-0.8.4.
The Call Control Interface (CCI) is specific to OpenSS7 and first appeared in strss7-0.8.4.
This is Version 0.8.4 of the CCI interface.

REFERENCES

[1]: CCI Revision 1.0.0, Call Control Interface (CCI) Specification, Draft 1, April 2003, (Edmonton), B. Bidulock, OpenSS7 Corporation. <http://www.openss7.org/docs/cci.pdf>